Accept Cookies help us deliver our services. By using our services, you agree to our use of cookies.

Hinge Guards

Hinge Guards
  • Hinge Guards
  • Hinge Guards
  • Hinge Guards





This kit will prevent the doors from being pulled out.

These kits fit inside of your doors, so if the hinge bolts are removed from the bulkhead which have captive nuts installed the door cannot just be pulled off.

They are very easy to install, and the beauty is that they are so simple, and will help to prevent a lot of door theft.
They are made for front and middle doors only, the back door is not as easy to remove.
The hinge guard is built to exact specification and was developed to fit all Defender models and years. It has been engineered for maximum protection and ease of fitment. Each Hinge Guard kit consists of two CAD engineered stainless steel plates which fit inside of each hinge point, restricting outward movement of the door with the bulkhead bolts removed. Fitting the Hinge Guards is incredibly easy with comprehensive fitting instructions supplied. Each door kit can be easily fitted in 20-30 minutes. After installation, only the top of each plate can be seen, providing an unobtrusive modification and deterrent to would-be thieves.
The upper guard has been notched so that it fits neatly around the dash padding without compromising security. Each plate has a carefully measured, very small offset to allow it to close around the door frame without tearing the door seal.
They are made of high grade 304 Stainless Steel, 2mm thick, thin enough to fit unobtrusively, more than thick enough to protect your hinges. The lower and rear hinges are profiled for a perfect fit across all variants.

Versions

Hinge Guard Set For 90

Hinge Guard Set for 90 Ex. VAT £25.00
£30.00

Hinge Guard Set For 110

Hinge Guard Set for 110 Ex. VAT £50
£60.00
06/01/2018